Archer MR200
AC750 Wireless Dual Band 4G LTE Router

Thumbnail for the TP-LINK Archer MR200 router with Gigabit WiFi, 3 100mbps ETH-ports and
0 USB-ports

The TP-LINK Archer MR200 router has Gigabit WiFi, 3 100mbps ETH-ports and 0 USB-ports.
It is also known as the TP-LINK AC750 Wireless Dual Band 4G LTE Router.

Quick links:
Default password/Login

Archer MR200 router specifications (specs)

System specs
CPU: 580 MHz
RAM: 64 MiB
Flash: 8 MiB
Custom firmwares: OpenWrt

Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands: n/a
WiFi throughput: n/a
WAN: 1 x 100mbps port
ETH: 3 x 100mbps ports
USB-ports: 0

Hard reset instructions for TP-LINK Archer MR200

If your Archer MR200 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your TP-LINK Archer MR200 in the following way(s):

Through the web interface

Open a browser and navigate to the web interface of the router (check default settings below)
In the menu look for System tools and under there find the Factory defaults option
On the Factory defaults page click on the Restore button to perform the reset.

Withe the RESET/WPS button

Have the unit powered on
Press and hold the reset (sometimes reset/WPS) button for 10 seconds with a paperclip or other sharp object.
When the SYS led start blinking quickly release the reset button and wait for router to boot back up.

The 30-30-30 reset

If the above instructions don't work you can always try the 30-30-30 reset as follows:

When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.

Default factory settings for TP-LINK Archer MR200

If you have performed a reset of your Archer MR200 device or not changed the defaults, you should be able to access it with the following settings:

Default username: admin TP-LINK router default password list
Default password: admin
Default subnet mask: 255.255.255.0

Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.