WAC6303D-S
802.11ac Wave 2 Dual-Radio Unified Pro Access Point

The ZyXEL WAC6303D-S router has Gigabit WiFi, 2 N/A ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 1600 Mpbs.
It is also known as the ZyXEL 802.11ac Wave 2 Dual-Radio Unified Pro Access Point.

Quick links:
Default password/Login

WAC6303D-S router specifications (specs)

Hard reset instructions for ZyXEL WAC6303D-S

If your WAC6303D-S router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your ZyXEL WAC6303D-S in the following way(s):

Through the web interface

1. Open web browser and go to the address of your router (check defaults below)
2. Log in with your username/password (default are below)
3. Under Maintenance, locate Backup/Restore and click it
4. Locate the section Factory defaults and click the reset button, if prompted click Ok
5. Wait for the router to reboot

With the reset button

1. Have the router plugged in and turned on
2. Locate the reset button which is marked reset and usually in a hole
3. With a paperclip or sharp pen, press and hold the reset button for 10 seconds until the SYS light starts to blink
   1. If the SYS light doesn't start to blink after 10 seconds:
      1. Keep holding the reset button pressed
      2. Turn off the modem / unplug it
      3. While still holding the reset button, start / plug in the router
      4. After about 20 seconds, the Power or SYS light will start blinking rapidly
      5. Release the reset button
4. When the light stops blinking and light up normally the router is reset.

The 30-30-30 reset

1. When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
2. While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.

Default factory settings for ZyXEL WAC6303D-S

Similar routers

AC-1027-I

RT-AC53

PLA5236

AP230

GL-B1300

C-75