WHR-300HP
Buffalo AirStation HighPower N300 Wireless Router
The Buffalo WHR-300HP router has 300mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
It is also known as the Buffalo Buffalo AirStation HighPower N300 Wireless Router.
Quick links:
Default password/Login
User Manuals
WHR-300HP router specifications (specs)
CPU: 400 MHz
RAM: 32 MiB
Flash: 4 MiB
Custom firmwares: OpenWrt
WiFi: 300mbps (bgn)
WiFi bands: 2.4GHz
WiFi throughput: n/a
WAN: 1 x 100mbps port
ETH: 4 x 100mbps ports
USB-ports: 0
Buffalo WHR-300 review (quick overview)
Here is the quick comparison of how the Buffalo WHR-300 compares to other routers on our site:
For a full list of routers and how they compare to the WHR-300HP, check the Router Buying Guide which will help you buy the most price-competitive router.
Hard reset instructions for Buffalo WHR-300HP
If your WHR-300HP router is not working as it should, dropping connections or not
being
responsive, you should first do a reset of the router to see if the problems persist. Other
scenarios where you might want to reset your router is if you've forgotten the password or
misconfigured it and can't get access anymore.
Your can reset your Buffalo WHR-300HP in the following way(s):
The 30-30-30 reset
There are no specific instructions for this model yet, but you can always do the 30-30-30 reset as follows:- When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
- While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
This process usually works for resetting any router to it's factory setting.
If that doesn't work be sure to check out the
questions and answers
incase someone else has had similar problems resetting their router.
Note: It is worth reading more about
how to reset routers with the 30 30 30 reset and what the risks and
considerations
are when resetting your router this way, instead of just rebooting it.
Default factory settings for Buffalo WHR-300HP
If you have performed a reset of your WHR-300HP device or not changed the defaults, you should be able to access it with the following settings:
Default subnet mask: 255.255.255.0
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.
Report error on page
(If info is incorrect)
