WAP11 v2.6

The Linksys WAP11 v2.6 router has 11mbps WiFi, 1 10mbps ETH-ports and 0 USB-ports.

Quick links:
Default password/Login
User Manuals

WAP11 v2.6 router specifications (specs)

System specs
CPU: n/a
RAM: n/a
Flash: n/a
Custom firmwares: None

Connectivity
WiFi: 11mbps (b)
WiFi bands: 2.4GHz
WiFi throughput: n/a
WAN: None
ETH: 1 x 10mbps port
USB-ports: 0

Hard reset instructions for Linksys WAP11 v2.6

If your WAP11 v2.6 router is not working as it should, dropping connections or not being responsive, you should first do a reset of the router to see if the problems persist. Other scenarios where you might want to reset your router is if you've forgotten the password or misconfigured it and can't get access anymore.
Your can reset your Linksys WAP11 v2.6 in the following way(s):

Through the web interface

Open your browser and navigate to the router interface (check default settings below)
Under the Administration tab you will find a sub-tab called Factory defaults
On the Factory defaults page click the button labeled Restore Factory Defaults

With the reset button

Have your unit powered on
Press and hold the reset button for at least 10 seconds until the power light starts blinking, then release.
When the power light goes solid, unplug the power to the router for 10 seconds
Plug the power back in and start the router
When the power light goes solid again the router is ready to use.

The 30-30-30 reset

If the above instructions don't work you can always try the 30-30-30 reset as follows:

When router is powered on, press the reset button and hold for 30 seconds. (Use a paper clip or something sharp)
While holding the reset button pressed, unplug the power of the router and hold the reset button for 30 seconds
While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

This process usually works for resetting any router to it's factory setting.

Note: It is worth reading more about how to reset routers with the 30 30 30 reset and what the risks and considerations are when resetting your router this way, instead of just rebooting it.

Default factory settings for Linksys WAP11 v2.6

If you have performed a reset of your WAP11 v2.6 device or not changed the defaults, you should be able to access it with the following settings:

Default Gateway IP: 192.168.1.251 Linksys login instructions
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.251
Note: If you are using the default settings you should change them to increase security and prevent unathorized access to your network.

WAP11 v2.6 Firmwares

Staying up to date with the latest firmware is a good idea to keep your router even more secure from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider flashing an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly increase the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Linksys WAP11 v2.6:

Linksys stock firmware for the WAP11 v2.6

Stock firmwares for the WAP11 v2.6 are available under the download section on the modem's support page. You can also refer to the router's manual for instructions on how to upgrade the firmware.