Mercku Login Instructions
How To Login to a Mercku Router And Access The Setup Page
The Mercku router web interface is the control panel for your router it's where all the settings are stored and changed. To make changes to your network you'll need to login to your Mercku router.
Requirements to access the Mercku web interface
Accessing the Mercku web interface is pretty straightforward and all you'll need is:
- Mercku router
- Access to the network, Either through LAN-cable or through Wi-Fi
- A web browser, which you clearly have.
Following are the instructions to connect to your Mercku router's interface for configuration and diagnotstics.
1. Make sure you are connected to your Mercku router
To be able to reach the setup pages of your Mercku router, you'll need to be connected to its network.
So start by connecting to the network, either through WiFi or through ethernet cable.
2. Open your web browser and navigate to 192.168.1.1
Open your browser and type the router's IP address into the address field. The most common IP for Mercku routers is: 192.168.1.1 If that IP address doesn't work, you can search the default Mercku IP address list for your specific model.
3. Enter the username and password for your Mercku router
In the username and password field, enter your current username and password and press enter / sign in.
Default login credentials for Mercku
If you're not sure about the username/password you can look at the default Mercku credentials to see what the defaults are, and how to reset to them.- The credentials can also be printed on the label on the back of your router.
That's it! You can now configure anything you want on the device.
How to configure your Mercku router
Once you have logged in to the Mercku admin interface you should be able to change any settings that are available.
Be careful when you configure your router so that you don't break the network.
What if my Mercku router or network stops working after a configuration change
In case you by mistake make some change that breaks your Mercku home network, you can always go back to zero by following the generic 30 30 30 hard reset trick.
This is usually the last resort, and if you still have access to the Mercku interface you can always login to try and revert the settings first (This of course assumes you wrote down the original value before changing it).