JJPlus Login Instructions
How To Login to a JJPlus Router And Access The Setup Page
The JJPlus router web interface is the control panel for your router it's where all the settings are stored and changed. To make changes to your network you'll need to login to your JJPlus router.
Requirements to access the JJPlus web interface
Accessing the JJPlus web interface is pretty straightforward and all you'll need is:
- JJPlus router
- Access to the network, Either through LAN-cable or through Wi-Fi
- A web browser, which you clearly have.
Following are the instructions to connect to your JJPlus router's interface for configuration and diagnotstics.
1. Make sure you are connected to your JJPlus router
To be able to reach the setup pages of your JJPlus router, you'll need to be connected to its network.
So start by connecting to the network, either through WiFi or through ethernet cable.
2. Open your web browser and navigate to 192.168.1.1
Open your browser and type the router's IP address into the address field. The most common IP for JJPlus routers is: 192.168.1.1 If that IP address doesn't work, you can search the default JJPlus IP address list for your specific model.
3. Enter the username and password for your JJPlus router
In the username and password field, enter your current username and password and press enter / sign in.
Default login credentials for JJPlus
If you're not sure about the username/password you can look at the default JJPlus credentials to see what the defaults are, and how to reset to them.- The credentials can also be printed on the label on the back of your router.
That's it! You can now configure anything you want on the device.
How to configure your JJPlus router
Once you have logged in to the JJPlus admin interface you should be able to change any settings that are available.
Be careful when you configure your router so that you don't break the network.
What if my JJPlus router or network stops working after a configuration change
In case you by mistake make some change that breaks your JJPlus home network, you can always go back to zero by following the generic 30 30 30 hard reset trick.
This is usually the last resort, and if you still have access to the JJPlus interface you can always login to try and revert the settings first (This of course assumes you wrote down the original value before changing it).