1. Home
  2. Default Router Passwords
  3. e-Netdata

e-Netdata Default Usernames & Passwords
The default credentials needed to login to your e-Netdata router

Info updated March 11, 2024

The majority of e-Netdata routers have a default username of -, a default password of -, and the default IP address of 192.168.1.1.

These e-Netdata credentials are needed when doing a login to the e-Netdata router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your e-Netdata router password, need to reset your e-Netdata router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

e-Netdata default Password List (Valid March 2024)

Model Default Username Default Password Default IP address


Instructions and common questions

Forgot your e-Netdata router password?

Have you changed the username and/or password of your e-Netdata router and forgotten what you changed it to?
Don't worry: all e-Netdata routers come with a default factory set password that you can revert to by following the instructions below.

Reset e-Netdata router to default password

If you decide to revert your e-Netdata router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your e-Netdata router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your e-Netdata router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely -/-).
If the factory reset didn't work, check out the e-Netdata 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my e-Netdata router with the default password

Make sure that you have followed the reset instructions correctly as the e-Netdata routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.