1. Home
  2. Default Router Passwords
  3. Well Communications

Well Communications Default Usernames & Passwords
The default credentials needed to login to your Well Communications router

Info updated April 18, 2023

The majority of Well Communications routers have a default username of admin, a default password of epicrouter, and the default IP address of 10.0.0.2.

These Well Communications credentials are needed when doing a login to the Well Communications router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Well Communications router password, need to reset your Well Communications router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Well Communications default Password List (Valid April 2023)

Model Default Username Default Password Default IP address
AWR-2440
AWR-2440 default factory settings 		Admin Admin 192.168.1.1
AWR-8210
AWR-8210 default factory settings 		admin epicrouter 10.0.0.2


Instructions and common questions

Forgot your Well Communications router password?

Have you changed the username and/or password of your Well Communications router and forgotten what you changed it to?
Don't worry: all Well Communications routers come with a default factory set password that you can revert to by following the instructions below.

Reset Well Communications router to default password

If you decide to revert your Well Communications router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Well Communications router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Well Communications router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/epicrouter).
If the factory reset didn't work, check out the Well Communications 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Well Communications router with the default password

Make sure that you have followed the reset instructions correctly as the Well Communications routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.