1. Home
  2. Default Router Passwords
  3. WeVO

WeVO Default Usernames & Passwords
The default credentials needed to login to your WeVO router

Info updated Sept. 17, 2024

The majority of WeVO routers have a default username of admin, a default password of DZY-W2914NSV2, and the default IP address of 192.168.10.1.

These WeVO credentials are needed when doing a login to the WeVO router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your WeVO router password, need to reset your WeVO router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

WeVO default Password List (Valid September 2024)

Model Default Username Default Password Default IP address
11AC Air Extender
11AC Air Extender default factory settings 		admin 123456789a! -
11AC NAS Router
11AC NAS Router default factory settings 		admin DZY-W2914NSV2 192.168.10.1
Hi1200AC
Hi1200AC default factory settings 		admin DZY-W2914NSV2 192.168.10.1
W2914NS v2
W2914NS v2 default factory settings 		admin DZY-W2914NSV2 192.168.10.1


Instructions and common questions

Forgot your WeVO router password?

Have you changed the username and/or password of your WeVO router and forgotten what you changed it to?
Don't worry: all WeVO routers come with a default factory set password that you can revert to by following the instructions below.

Reset WeVO router to default password

If you decide to revert your WeVO router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your WeVO router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your WeVO router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/DZY-W2914NSV2).
If the factory reset didn't work, check out the WeVO 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my WeVO router with the default password

Make sure that you have followed the reset instructions correctly as the WeVO routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.