Synology Default Usernames & Passwords
The default credentials needed to login to your Synology router
Info updated Oct. 2, 2024
The majority of Synology routers have a default username of admin
, a default password of -
, and the default IP address of 192.168.1.1
.
These Synology credentials are needed when doing a login to the Synology router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Synology router password, need to reset your Synology router to its factory default password, or the password reset doesn't work.
Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.Synology default Password List (Valid October 2024)
Model | Default Username | Default Password | Default IP address |
DiskStation DS414 DiskStation DS414 default factory settings |
admin | - | - |
RT1900ac RT1900ac default factory settings |
admin | - | 192.168.1.1 |
RT2600ac RT2600ac default factory settings |
admin | - | 192.168.1.1 |
RT6600ax RT6600ax default factory settings |
admin | - | 192.168.1.1 |
Instructions and common questions
Forgot your Synology router password?
Have you changed the username and/or password of your Synology router and forgotten what you changed it to?
Don't worry: all Synology routers come with a default factory set password that you can revert to by following the instructions below.
Reset Synology router to default password
If you decide to revert your Synology router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Synology router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Synology router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin
/-
).
If the factory reset didn't work, check out the Synology 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Synology router with the default password
Make sure that you have followed the reset instructions correctly as the Synology routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.