SeeedStudio Default Usernames & Passwords
The default credentials needed to login to your SeeedStudio router
Info updated March 28, 2024
The majority of SeeedStudio routers have a default username of debian, a default password of temppwd, and the default IP address of 192.168.100.1.
These SeeedStudio credentials are needed when doing a login to the SeeedStudio router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your SeeedStudio router password, need to reset your SeeedStudio router to its factory default password, or the password reset doesn't work.
Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.SeeedStudio default Password List (Valid March 2024)
| Model | Default Username | Default Password | Default IP address |
|
BeagleBone Green BeagleBone Green default factory settings |
debian | temppwd | 192.168.7.2 |
|
BeagleBone Green Wireless BeagleBone Green Wireless default factory settings |
debian | temppwd | 192.168.7.2 |
|
LinkIt Smart 7688 LinkIt Smart 7688 default factory settings |
root | change on install | 192.168.100.1 |
|
ReSpeaker Core ReSpeaker Core default factory settings |
root | root | 192.168.100.1 |
Instructions and common questions
Forgot your SeeedStudio router password?
Have you changed the username and/or password of your SeeedStudio router and forgotten what you changed it to?
Don't worry: all SeeedStudio routers come with a default factory set password that you can revert to by following the instructions below.
Reset SeeedStudio router to default password
If you decide to revert your SeeedStudio router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your SeeedStudio router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your SeeedStudio router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely debian/temppwd).
If the factory reset didn't work, check out the SeeedStudio 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my SeeedStudio router with the default password
Make sure that you have followed the reset instructions correctly as the SeeedStudio routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.
