1. Home
  2. Default Router Passwords
  3. QTECH

QTECH Default Usernames & Passwords
The default credentials needed to login to your QTECH router

Info updated Dec. 9, 2024

The majority of QTECH routers have a default username of admin, a default password of admin, and the default IP address of 192.168.1.1.

These QTECH credentials are needed when doing a login to the QTECH router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your QTECH router password, need to reset your QTECH router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

QTECH default Password List (Valid December 2024)

Model Default Username Default Password Default IP address
QBR-2041WW
QBR-2041WW default factory settings 		admin admin 192.168.1.1
QDSL-1040WU rev.2
QDSL-1040WU rev.2 default factory settings 		admin admin 192.168.1.1


Instructions and common questions

Forgot your QTECH router password?

Have you changed the username and/or password of your QTECH router and forgotten what you changed it to?
Don't worry: all QTECH routers come with a default factory set password that you can revert to by following the instructions below.

Reset QTECH router to default password

If you decide to revert your QTECH router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your QTECH router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your QTECH router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/admin).
If the factory reset didn't work, check out the QTECH 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my QTECH router with the default password

Make sure that you have followed the reset instructions correctly as the QTECH routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.