1. Home
  2. Default Router Passwords
  3. Netcore

Netcore Default Usernames & Passwords
The default credentials needed to login to your Netcore router

Info updated Dec. 5, 2024

The majority of Netcore routers have a default username of guest, a default password of guest, and the default IP address of 192.168.1.1.

These Netcore credentials are needed when doing a login to the Netcore router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Netcore router password, need to reset your Netcore router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Netcore default Password List (Valid December 2024)

Model Default Username Default Password Default IP address
605GR
605GR default factory settings 		guest guest -
NW502
NW502 default factory settings 		guest guest 192.168.1.1
NW616
NW616 default factory settings 		guest guest 192.168.1.1
NW702
NW702 default factory settings 		guest guest 192.168.1.1
NW705P
NW705P default factory settings 		guest guest 192.168.1.1
NW725
NW725 default factory settings 		guest guest 192.168.1.1
NW725P
NW725P default factory settings 		guest guest 192.168.1.1


Instructions and common questions

Forgot your Netcore router password?

Have you changed the username and/or password of your Netcore router and forgotten what you changed it to?
Don't worry: all Netcore routers come with a default factory set password that you can revert to by following the instructions below.

Reset Netcore router to default password

If you decide to revert your Netcore router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Netcore router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Netcore router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely guest/guest).
If the factory reset didn't work, check out the Netcore 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Netcore router with the default password

Make sure that you have followed the reset instructions correctly as the Netcore routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.