1. Home
  2. Default Router Passwords
  3. IP-COM

IP-COM Default Usernames & Passwords
The default credentials needed to login to your IP-COM router

Info updated Sept. 9, 2024

The majority of IP-COM routers have a default username of admin, a default password of admin, and the default IP address of 192.168.0.254.

These IP-COM credentials are needed when doing a login to the IP-COM router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your IP-COM router password, need to reset your IP-COM router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

IP-COM default Password List (Valid September 2024)

Model Default Username Default Password Default IP address
AP345
AP345 default factory settings 		admin admin 192.168.0.254
W40AP v9
W40AP v9 default factory settings 		admin admin 192.168.0.254
W63AP
W63AP default factory settings 		admin admin 192.168.0.254


Instructions and common questions

Forgot your IP-COM router password?

Have you changed the username and/or password of your IP-COM router and forgotten what you changed it to?
Don't worry: all IP-COM routers come with a default factory set password that you can revert to by following the instructions below.

Reset IP-COM router to default password

If you decide to revert your IP-COM router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your IP-COM router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your IP-COM router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/admin).
If the factory reset didn't work, check out the IP-COM 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my IP-COM router with the default password

Make sure that you have followed the reset instructions correctly as the IP-COM routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.