1. Home
  2. Default Router Passwords
  3. Control4

Control4 Default Usernames & Passwords
The default credentials needed to login to your Control4 router

Info updated May 29, 2024

The majority of Control4 routers have a default username of -, a default password of -, and the default IP address of 192.168.1.1.

These Control4 credentials are needed when doing a login to the Control4 router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Control4 router password, need to reset your Control4 router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Control4 default Password List (Valid May 2024)

Model Default Username Default Password Default IP address


Instructions and common questions

Forgot your Control4 router password?

Have you changed the username and/or password of your Control4 router and forgotten what you changed it to?
Don't worry: all Control4 routers come with a default factory set password that you can revert to by following the instructions below.

Reset Control4 router to default password

If you decide to revert your Control4 router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Control4 router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Control4 router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely -/-).
If the factory reset didn't work, check out the Control4 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Control4 router with the default password

Make sure that you have followed the reset instructions correctly as the Control4 routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.