1. Home
  2. Default Router Passwords
  3. Anker

Anker Default Usernames & Passwords
The default credentials needed to login to your Anker router

Info updated Sept. 25, 2023

The majority of Anker routers have a default username of admin, a default password of admin, and the default IP address of 192.168.0.1.

These Anker credentials are needed when doing a login to the Anker router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.

Below the table are also instructions on what to do incase you forget your Anker router password, need to reset your Anker router to its factory default password, or the password reset doesn't work.

Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.

Anker default Password List (Valid September 2023)

Model Default Username Default Password Default IP address
Uspeed Dual Band Router 300Mbps
Uspeed Dual Band Router 300Mbps default factory settings 		admin admin 192.168.0.1
Uspeed Dual Band Router 600Mbps
Uspeed Dual Band Router 600Mbps default factory settings 		admin admin 192.168.0.1


Instructions and common questions

Forgot your Anker router password?

Have you changed the username and/or password of your Anker router and forgotten what you changed it to?
Don't worry: all Anker routers come with a default factory set password that you can revert to by following the instructions below.

Reset Anker router to default password

If you decide to revert your Anker router to it's factory defaults, you should do the 30-30-30 reset as follows:

  1. When your Anker router is powered on, press and hold the reset button for 30 seconds.
  2. While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
  3. While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.

Your Anker router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely admin/admin).
If the factory reset didn't work, check out the Anker 30 30 30 factory reset guide .


Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).

I still can't access my Anker router with the default password

Make sure that you have followed the reset instructions correctly as the Anker routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.