Allied Telesis Default Usernames & Passwords
The default credentials needed to login to your Allied Telesis router
Info updated Sept. 16, 2024
The majority of Allied Telesis routers have a default username of manager, a default password of friend, and the default IP address of 192.168.1.1.
These Allied Telesis credentials are needed when doing a login to the Allied Telesis router's web interface to change any settings.
Since some of the models don't follow the standards, you can see those in the table below.
Below the table are also instructions on what to do incase you forget your Allied Telesis router password, need to reset your Allied Telesis router to its factory default password, or the password reset doesn't work.
Tip: Press ctrl+f (or cmd+f on Mac) to quickly search for your model number.Allied Telesis default Password List (Valid September 2024)
| Model | Default Username | Default Password | Default IP address |
|
AT-TQ2403 AT-TQ2403 default factory settings |
manager | friend | 192.168.1.230 |
|
AT-TQ3600 AT-TQ3600 default factory settings |
manager | friend | - |
|
AT-WR2304N AT-WR2304N default factory settings |
manager | friend | 192.168.1.1 |
Instructions and common questions
Forgot your Allied Telesis router password?
Have you changed the username and/or password of your Allied Telesis router and forgotten what you changed it to?
Don't worry: all Allied Telesis routers come with a default factory set password that you can revert to by following the instructions below.
Reset Allied Telesis router to default password
If you decide to revert your Allied Telesis router to it's factory defaults, you should do the 30-30-30 reset as follows:
- When your Allied Telesis router is powered on, press and hold the reset button for 30 seconds.
- While still holding the reset button pressed, unplug the power of the router and hold the reset button for another 30 seconds
- While still holding the reset button down, turn on the power to the unit again and hold for another 30 seconds.
Your Allied Telesis router should now be reset to its brand new factory settings, Check the table to see what those are (Most likely manager/friend).
If the factory reset didn't work, check out the Allied Telesis 30 30 30 factory reset guide .
Important: Remember to change the default username and password to increase the security of your router after the factory reset, as the default passwords are available all over the web (like here).
I still can't access my Allied Telesis router with the default password
Make sure that you have followed the reset instructions correctly as the Allied Telesis routers should always rever to their factory default settings when reset.
Otherwise, there is always the risk that your router is damaged and might need to be repaired or replaced.
